& nbsp; Many people think that the mechanical strength of elevators is relatively high when using them, so they do not strictly follow the installation methods in the manual during the installation process. Little do they know that this will result in increased wear and tear of parts and insensitivity to work. In addition, they should pay attention to the corresponding installation precautions in the working environment and not be careless. The correct installation, use, and protection of elevators are important steps in ensuring the normal operation of mechanical equipment. Therefore, when installing the elevator, it is necessary to strictly follow the following equipment operation related matters and carefully install and use it.

  & nbsp; What kind of effect can the installation elevator have? Before installation, it is necessary to confirm whether the motor and elevator are intact, and strictly check whether the dimensions of the various parts that connect the motor and elevator match. Here are the dimensions of the motor's positioning boss, input shaft, and elevator groove, as well as the cooperative service.

  & nbsp; Unscrew the screws on the outer dust-proof hole of the elevator flange, adjust the PCS system clamping ring to align its side hole with the dust-proof hole, and tighten it by inserting it into the inner hexagon. Afterwards, remove the motor shaft key. Connect the motor naturally with the elevator. It is necessary to ensure that the output shaft of the elevator is concentric with the input shaft of the motor during connection, and that the outer flanges of both are parallel. Different degrees of alignment can lead to motor shaft breakage or elevator gear wear.

  & nbsp; Additionally, during installation, it is strictly prohibited to use hammers or other tools to strike, in order to avoid excessive axial or radial forces that may damage bearings or gears. It is necessary to tighten the device bolts before tightening the tension bolts. Before installation, wipe off the rust proof oil on the motor input shaft, positioning boss, and elevator connection parts with gasoline or zinc sodium water. The intention is to ensure the tightness of the connection and the sensitivity of the work, while avoiding unnecessary wear and tear.